For 1990-2009 cars only
Removal Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the quick disconnect from the concentric slave cylinder. Refer to Clutch Master Cylinder Replacement .
- Remove the transmission.
- Remove the bolts which are securing the concentric slave cylinder to the clutch housing shaft.
- Remove the slave cylinder from the transmission input shaft.
- Remove the bearing from the slave cylinder.
Installation Procedure
- Install the bearing to the slave cylinder.
- Install the slave cylinder to the transmission input shaft ensuring that the bleed screw and coupling are positioned through the transmission opening.
- Install the two bolts which are securing the concentric slave cylinder to the clutch housing shaft.
- Install the transmission.
- Install the quick disconnect to the concentric slave cylinder. Refer to Clutch Master Cylinder Replacement .
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the concentric slave cylinder bolts to 8 N·m (71 lb in).
