Important: Never use fluid that you have bled from a system to fill the reservoir. The fluid may be aerated or contaminated.

1. Fill the reservoir with DOT 3 brake fluid GM P/N 1052535 or the equivalent. Do not overfill the system.
2. Depress and hold down the clutch pedal.
3. Open the bleed screw, located on the side of the transmission above the quick connect coupling, to expel any air.
4. Close the bleed screw and release the clutch pedal.

Important: Ensure no air is drawn into the clutch system.

5. Repeat steps 2, 3, and 4 until all the air is out of the clutch system.

5.1.	Check and refill the reservoir as needed while bleeding.

5.2.	After bleeding, pump the clutch pedal several times. If the clutch engagement is not satisfactory, repeat the bleeding procedure.

6. If the previous procedures are unsuccessful, perform the following steps:

6.1.	Remove the reservoir cap.

6.2.	Pump the clutch pedal very fast for 30  seconds.

6.3.	Stop pumping and let the air escape.

6.4.	Repeat this procedure as necessary.