GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 167285  Size: SH
  1. Remove the pushrod from the clutch pedal.
  2. Remove the nut and the bolt from the retainer.
  3. Remove the retainer.

  4. Object Number: 167288  Size: SH
  5. Remove the washer and the bushing from the shaft.
  6. Remove the shaft from the bracket. Slide a long screw or rod into the bracket in order to hold the brake pedal in place.
  7. Remove the clutch pedal and the bushing.

Installation Procedure

  1. Lightly grease the inside and the outside of the new bushing.

  2. Object Number: 167285  Size: SH
  3. Install the new bushing into the bracket.
  4. Install the clutch pedal. Remove the long screw or rod supporting the brake pedal while installing the clutch pedal into the bracket.

  5. Object Number: 167288  Size: SH
  6. Install the shaft into the bracket.
  7. Install the retainer.
  8. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  9. Install the bolt and the nut onto the retainer.
  10. Tighten
    Tighten the retainer nut to 20 N·m (15 lb ft).

  11. Install the pushrod onto the clutch pedal.