Hub and Drum Assembly Replacement All Models

Tools Required

J 2222-C Wheel Bearing Nut Wrench

1. Raise the vehicle until the wheel is free to rotate.
2. Remove the wheel and tire.



3. Remove the axle shaft (5). Refer to Axle Shaft Replacement .
4. Remove the retaining ring (10).
5. Remove the wheel bearing adjusting nut key (9).



6. Remove the adjusting nut using the J 2222-C .



7. Remove the hub and drum (3).
8. Inspect all the parts. Replace any parts as necessary.

1. Install the hub and drum (3) to the axle tube.

•	Be sure the bearings and the oil seal are positioned properly.

•	Apply a light coat of high melting point EP bearing lubricant to the contact surfaces and the outside of the axle tube.

2. Install the wheel bearing adjusting nut key (9) into the key way.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the adjusting nut using the J 2222-C .
4. Adjust the bearing preload. Refer to Wheel Bearing Adjustment .



5. Install the key (9).
6. Install the retaining ring (10).
7. Install the axle shaft (5). Refer to Axle Shaft Replacement .
8. Install the wheel and tire.
9. Lower the vehicle.