For 1990-2009 cars only
Checking Backlash
- Mount a J 39704 with a magnetic base to the axle housing.
- Place the indicator tip of the J 39704 on the heel end (1) of the ring gear tooth.
- Check the backlash at three equally spaced points.
- If the backlash needs adjustment, remove the differential case from the housing.
- If the backlash is correct, change the preload on each side by an equal amount.
- Make a final gear pattern check. Refer to Gear Tooth Contact Pattern Inspection .
Important: The measurement must not vary more than 0.05 mm (0.002 in) between the points checked.
Important: The reduction in the shim pack on one side must be equal to the increase in the shim pack on the other side.
Less Than 0.13 mm (0.005 in) | 0.13-0.23 mm (0.005-0.009 in) | Greater Than 0.23 mm (0.009 in) |
|---|---|---|
Move shims from the ring gear side to the side opposite of the ring gear | No change | Move shims from the side opposite of the ring to the ring gear side. |
