GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 235019  Size: SH
  1. Disconnect the crankcase vent tube from the rear intermediate duct.

  2. Object Number: 235020  Size: SH
  3. Loosen the rear intermediate duct clamps and remove.

  4. Object Number: 235028  Size: SH
  5. Remove air duct fastener and duct.

  6. Object Number: 325556  Size: SH
  7. Remove the accelerator cable from the from the throttle pulley.

  8. Object Number: 325557  Size: MH
  9. Remove the cable from the accelerator cable bracket by releasing the accelerator cable retainer locking tangs.

  10. Object Number: 441431  Size: SH
  11. Remove the accelerator cable end from the accelerator pedal lever.

  12. Object Number: 26786  Size: SH
  13. Remove the accelerator cable from the dash panel (1) by releasing the retainer locking tangs.

Installation Procedure

Important: Observe the following when installing the accelerator cable in order to insure the proper operation of the accelerator controls:

   • Replace the accelerator cable with an identical replacement part.
   • Do not route the accelerator cable within 13 mm (0.52 in) at any point of travel of wires, cables, hoses or other flexible components.
   • The accelerator controls operate without binding between closed throttle and wide open throttle position.


    Object Number: 26786  Size: SH
  1. Insert the accelerator cable through the dash panel (1) until the locking tangs are fully seated and locked into position.

  2. Object Number: 441431  Size: SH
  3. Install the accelerator cable to the accelerator pedal lever.

  4. Object Number: 325557  Size: MH
  5. Insert the accelerator cable through the accelerator cable support until the locking tangs are fully seated and locked into position.

  6. Object Number: 325556  Size: SH

    Important: Do not twist or kink the accelerator cable in order to insure the cable is properly seated in the throttle pulley groove.

  7. Insert the accelerator cable into the throttle pulley slot and groove.

  8. Object Number: 235028  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  9. Install air inlet duct and fastener.
  10. Tighten
    tighten fastener to 2.5N·m(22 lb in).


    Object Number: 235020  Size: SH
  11. Install the rear intermediate duct.

  12. Object Number: 235019  Size: SH
  13. Install the crankcase vent tube to the rear intermediate duct.
  14. With engine OFF, check to see that the accelerator pedal does not bind.