Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
Caution: This vehicle is equipped with a Supplemental Restraint System (SRS).
Failure to follow the correct procedure could cause the following conditions:
| • | Unnecessary SRS system repairs |
| • | Refer to SRS Component Views in order to determine if you are
performing service on or near the SRS components or the SRS wiring. |
| • | If you are performing service on or near the SRS components or
the SRS wiring, disable the SRS system. Refer to Disabling the SRS System
in SRS. |
- Disconnect the negative battery cable.
- Remove the glove box. Refer to
Instrument Panel Storage Compartment Replacement
in Instrument
Panel, Gages, and Console.
- Remove passenger air bag if equipped. Refer to
Inflatable Restraint Instrument Panel Module Replacement
in
SIR.
Caution: The sensing and the diagnosis module (SDM) can maintain
sufficient voltage to deploy the airbags and pretensioners for up to 1 minute after
the ignition has been turned OFF and the fuse has been removed. If the airbags and
pretensioners are not disconnected, do not begin service until one minute has been
passed after disconnecting power to the SDM. Failure to do so may cause personal injury.
- Disconnect the connector to the intake air control
door actuator.
- Remove 3 screws that secure the intake air control door actuator
to blower unit.
- Remove the intake air control door actuator by gently snapping the actuator.
Installation Procedure
- Install the intake air control door actuator by gently
snapping the actuator.
- Install 3 screws that secure the intake air control door actuator
to the blower unit.
- Connect the connector to the intake air control door actuator.
- Install passenger air bag if equipped. Refer to
Inflatable Restraint Instrument Panel Module Replacement
in
SIR.
- Install the glove box. Refer to
Instrument Panel Storage Compartment Replacement
in Instrument
Panel, Gages, and Console.
- Connect the negative battery cable.
