Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
Notice: Perform the following steps before beginning any vehicle lifting or
jacking procedure:
| • | Remove or secure all of the vehicle's contents in order to avoid
any shifting or any movement that may occur during the vehicle lifting or
jacking procedure. |
| • | The lifting equipment or the jacking equipment weight rating must
meet or exceed the weight of the vehicle and any vehicle contents. |
| • | The lifting equipment or the jacking equipment must meet the operational
standards of the lifting equipment or jacking equipment's manufacturer. |
| • | Perform the vehicle lifting or jacking procedure on a clean, hard,
dry, level surface. |
| • | Perform the vehicle lifting or jacking procedure only at the identified
lift points. DO NOT allow the lifting equipment or jacking equipment to contact
any other vehicle components. |
- Raise and suitably support the vehicle.
- Remove the intake manifold support bracket bolts.
- Remove the intake manifold support bracket.
- Disconnect the knock sensor (KS) electrical connector.
- Remove the KS bolt.
- Remove the KS.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the KS with the bolt.
Tighten
Tighten the KS bolt to 20 N·m (15 lb ft).
- Connect the KS electrical connector.
- Install the intake manifold support bracket with the bolts.
Tighten
| • | Tighten the intake manifold support bracket upper bolts to 25 N·m (18 lb ft). |
| • | Tighten the intake manifold support bracket lower bolts to 45 N·m (33 lb ft). |
- Lower the vehicle.
- Connect the negative battery cable.
