Tools Required

J 29843-9 Door Lock Striker and Seat Belt TORX® Wrench

1. Remove the cover (2) from the upper seat belt anchor.
2. Use the J 29843-9 in order to remove the bolt (1) securing the upper seat belt anchor from the rear window pillar (3).
3. Remove the upper seat belt anchor from the rear window pillar (3).
4. Raise the carpeting in order to expose the lower seat belt anchor bolt (5).
5. Use the J 29843-9 in order to remove the bolt (5) securing the lower seat belt anchor (4) from the floor.
6. Remove the plastic trim cover from the rear window pillar (3) trim panel. Slide the belt webbing through the slot.
7. Remove the driver's side rear quarter trim with RPO-C34, rear A/C only. Refer to Rear Quarter Lower Trim Panel Replacement in Interior Trim.



8. Use the J 29843-9 in order to remove the bolt securing the retractor from the rear window pillar.
9. Remove the retractor side seat belt from the vehicle.
10. Remove the retractor from the vehicle.

1. Install the retractor side seat belt to the vehicle.
2. Install the retractor to the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Use the J 29843-9 in order to install the bolt securing the retractor to the rear window pillar.

Tighten
Tighten the seat belt retractor bolt rear window pillar to 43 N·m (32 lb ft).

4. Install the drivers side rear quarter trim with RPO-C34 rear AC only. Refer to Rear Quarter Lower Trim Panel Replacement in Interior Trim.



5. Slide the belt webbing through the slotted trim cover. Then snap the plastic trim cover to the rear window pillar (3) trim panel.
6. Install the lower seat belt anchor (4) to the floor.
7. Use the J 29843-9 in order to install the bolt (5) securing the lower seat belt anchor (4) to the floor.

Tighten
Tighten the lower seat belt anchor bolt rear window pillar to 43 N·m (32 lb ft).

8. Install the upper seat belt anchor (1) to the rear window pillar (3).
9. Use the J 29843-9 in order to install the bolt (1) securing the upper seat belt anchor to the rear window pillar (3).

Tighten
Tighten the upper seat belt anchor bolt rear window pillar to 43 N·m (32 lb ft).

10. Install the cover (2) to the upper seat belt anchor.