GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Tracker - 4WD 🢒 Body and Accessories 🢒 Body Rear End 🢒 Hinge Replacement - Endgate Upper

Removal Procedure

    Object Number: 470823 Size: SH
  1. Open the endgate panel.
  2. Suitably support the endgate panel.
  3. Mark the position of the upper hinge to the endgate panel and the door jamb in order to aid in the reassembly process.
  4. Remove the 2 bolts (2) that retain the endgate upper hinge (1) to the endgate panel.
  5. Remove the 3 bolts (3) that retain the endgate upper hinge (1) to the door jamb.
  6. Remove the endgate upper hinge (1) from the vehicle.

Installation Procedure

    Object Number: 470823 Size: SH
  1. Install the endgate upper hinge (1) to the vehicle. Secure the hinge to the door jamb with the 3 bolts (3). Do not tighten completely at this time.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the 2 bolts (2) that retain the endgate upper hinge (1) to the endgate panel.

    3. Tighten
    Tighten the endgate upper hinge mounting bolts to 34 N·m (25 lb ft).

  3. Remove the support from the endgate panel.
  4. Close the endgate panel.