- Clean the crankshaft balancer
with a cloth and denatured alcohol.
- Clean the belt grooves of all dirt or debris with a wire brush.
Caution: Refer to Safety Glasses Caution in the Preface section.
- Dry the crankshaft balancer with compressed air.
- Inspect the crankshaft balancer for the following:
| • | Worn, grooved, or damaged hub seal surface. |
| • | A crankshaft balancer hub seal surface with excessive scoring, grooves,
rust or other damage must be replaced. |
| • | Minor imperfections on the hub seal surface may be removed with polishing
compound or fine grade emery cloth. |
| | Important: In order for the belt to track properly, the belt grooves should be
free of all dirt or debris.
|
| • | Dirty or damaged belt grooves. |
| • | The balancer belt grooves should be free of any nicks, gouges, or other
damage that may not allow the belt to track properly. |
| • | Minor imperfections may be removed with a fine file. |
| • | Worn, chunking or deteriorated rubber between the hub and pulley. |
