Step | Action | Yes | No |
|---|---|---|---|
DEFINITION: The clutch grabs or chatters during engagement. | |||
1 | Inspect the engine mounting fasteners. Are the engine mounts loose? | Go to Step 2 | Go to Step 3 |
2 | Tighten the engine mounting fasteners to the specified torque. Does the clutch still grab? | Go to Step 3 | System OK |
3 | Check for damaged engine mounts. Are any engine mounts damaged? | G to Step 4 | Go to Step 5 |
4 | Replace the engine mount. Does the clutch still grab? | Go to Step 5 | System OK |
5 | Check the pressure plate assembly for burned or smeared resin. Is there burned or smeared resin on the pressure plate? | Go to Step 6 | Go to Step 7 |
6 | If the burns or smears are superficial, clean or sand off the excess resin. If the pressure plate assembly is burned or has heat checked parts, then replace the pressure plate assembly. Refer to Clutch Assembly Replacement . Does the clutch still grab? | Go to Step 7 | System OK |
7 | Check for a warped pressure plate. Is the pressure plate warped? | Go to Step 8 | Go to Step 9 |
8 | Replace the pressure plate. Refer to Clutch Assembly Replacement . Does the clutch still grab? | Go to Step 9 | System OK |
9 | Check for oil on the clutch pressure plate facing or a burned or glazed facing. Is there oil on the clutch pressure plate facing or a burned or glazed facing? | Go to Step 10 | Go to Step 11 |
10 |
Does the clutch still grab? | Go to Step 11 | System OK |
11 | Check for worn splines on the transmission input shaft. Are there worn splines on the transmission input shaft? | Go to Step 13 | Go to Step 12 |
12 | Inspect the release bearing on the input shaft bearing retainer. Is the release bearing binding on the bearing retainer? | Go to Step 13 | -- |
13 | Replace the necessary components. Does the clutch still grab? | -- | System OK |
