- Raise the vehicle. Support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- If the vehicle is equipped with an engine skid plate, remove the four bolts that hold the skid plate in place. Remove the front skid plate from the vehicle.
- Remove the front axle housing oil level/filler plug (1) from the front axle housing.
- Inspect the oil level. The oil level should be even with the bottom of the front axle housing oil level/filler plug hole (1) . If the oil level is low and no oil leaks exist, adjust the oil level using 80W-90 GL5 lubricant GM P/N 12345977 (Canadian P/N 10953482), or equivalent.
- Install the front axle housing oil level/filler plug (1) into the front axle housing.
- If the vehicle is equipped with an engine skid plate, install the front skid plate to the vehicle. Secure the skid plate with four bolts.
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the front axle housing oil level/filler plug to 40 N·m
(30 lb ft).
Tighten
Tighten the front skid plate bolts to 54 N·m (40 lb ft).
