For 1990-2009 cars only
Removal Procedure
- Raise and suitably support the hood.
- Remove the 2 bolts (3) the hood primary latch (1) from the front upper panel.
- Remove the hood primary latch release cable from the hood primary latch (1).
- Remove the hood primary latch (1) from the vehicle.
Installation Procedure
- Install the hood primary latch release cable to the hood primary latch (1).
- Install the hood primary latch (1) to the vehicle. Secure the latch with the 2 retaining bolts. Do not fully tighten the bolts.
- Adjust the hood primary latch (1) in order to ensure that the striker shaft lines up with the center groove of the hood primary latch (1).
- Adjust the hood primary latch in order to ensure that the hood is flush with the front fenders. Refer to Body Panel Adjustment .
- Lower the hood.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the hood latch retaining bolts to 10 N·m (89 lb in).
