Did you review the Instrument Cluster Circuit Description and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Instrument Panel, Gages and Console

Verify that the instrument cluster gauges are inoperative.

Do the gages operate normally?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

1. Disconnect the instrument cluster connector C1.
2. Test for an open condition between cavity 14 and a good ground.

Does an open condition exist?

Go to Step 4

Go to Step 5

Repair the open in the BLK/WHT wire between the instrument cluster and the junction block C4 cavity 1.

Did you complete the repair?

Go to Step 9

--

1. Disconnect the instrument cluster connector C3.
2. Test for a open condition between cavity 2 and G103.

Does an open condition exist?

Go to Step 6

Go to Step 7

Repair the short in the BLK/YEL wire between the instrument cluster and G103.

Did you complete the repair?

Go to Step 9

--

Inspect the instrument cluster for any damage to the cluster or printed circuit.

Is there any damage to the instrument cluster or printed circuit?

Go to Step 8

Go to Testing for Intermittent Conditions and Poor Connections

Repair or replace the instrument cluster or printed circuit.

Did you complete the repair?

Go to Step 9

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3