Step | Action | Yes | No |
|---|---|---|---|
DEFINITION: This table diagnoses the rear wiper operates normally but will not return to the park position when the rear wiper operation is cancelled. | |||
1 | Did you review the Wiper/Washer System Operation and perform the necessary inspections? | Go to Step 2 | |
2 | Verify that the rear wiper will not park when the wiper operation is cancelled. Does the rear wiper park? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
3 |
Does the test light illuminate? | Go to Step 4 | Go to Step 8 |
4 |
Did you test an open between cavity 1 and cavity 4 of the rear wiper motor connector? | Go to Step 5 | Go to Step 6 |
5 |
Did you test an open in the ORN wire? | Go to Step 9 | Go to Step 7 |
6 | Replace the rear wiper motor. Refer to Rear Window Wiper Motor Replacement . Did you complete the replacement? | Go to Step 10 | -- |
7 | Replace the rear wiper/washer switch. Refer to Rear Window Wiper and Washer Switch Replacement . Did you complete the replacement? | Go to Step 10 | -- |
8 | Repair the open in the YEL/BLU wire between cavity 2 of the rear wiper motor and cavity 6 of connector C5 at the Junction Block. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 10 | -- |
9 | Repair the open in the ORN wire between cavity 1 of the rear wiper motor connector and cavity 5 of the rear wiper/washer switch connector. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 10 | -- |
10 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
