Did you review the Exterior Lights Circuit Description and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Lighting Systems

Verify that the Hazards are inoperative.

Do the Hazards work normally?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

1. Disconnect the Turn/Hazard Flasher connector.
2. Connect a test lamp between cavity 2 of the Turn/Hazard Flasher and ground.

Does the test lamp illuminate?

Go to Step 4

Go to Step 5

1. Push the Hazard Switch to the ON position.
2. Connect the fused jumper wire between cavity 2 and terminal 3 of the Turn/Hazard Flasher.

Do the hazard lamps illuminate?

Go to Step 6

Go to Step 7

Repair the open condition in the BLK wire from the junction block to S207. Refer to Wiring Repairs in Wiring Systems.

Did you complete the repair?

Go to Step 10

--

Replace the Turn/Hazard Flasher. Refer to Hazard and Turn Signal Flasher Replacement .

Did you complete the repair?

Go to Step 10

--

1. Reconnect the Turn/Hazard Flasher connector.
2. Disconnect the Hazard Switch connector.
3. Connect a fused jumper wire between cavity 1 and cavity 3 of the Hazard Switch assembly .

Does the left front turn lamp flash?

Go to Step 8

Go to Step 9

Replace the Hazard Switch assembly.

Did you complete the repair?

Go to Step 10

--

Repair the open in the GRN wire from the Turn/Hazard Flasher and the Hazard Switch. Refer to Wiring Repairs in Wiring Systems.

Did you complete the repair?

Go to Step 10

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3