Step | Action | Yes | No |
|---|---|---|---|
1 | Did you review the Headlights/Daytime Running Lights (DRL) Circuit Description and perform the necessary inspections? | Go to Step 2 | |
2 | Verify that the High Beam Indicator is inoperative. Does the Indicator operate normally? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
3 | Using a J 35616-200 backprobe connector C1, cavity 6 of the instrument panel cluster assembly to ground. Does the test lamp illuminate? | Go to Step 4 | Go to Step 9 |
4 | Using a J 36169-A fused jumper wire, backprobe connector C1, cavity 4 of the instrument panel cluster assembly to ground. Does the high beam indicator lamp light? | Go to Step 6 | Go to Step 5 |
5 | Test for an open in the IP cluster printed circuit . Does an open condition exist? | Go to Step 8 | Go to Step 7 |
6 | Repair the open RED wire between connector C1, cavity 4 of the instrument panel cluster assembly and S234. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 10 | -- |
7 | Replace the high beam indicator lamp. Did you complete the repair? | Go to Step 10 | -- |
8 | Replace IP cluster printed circuit. Refer to Printed Instrument Cluster Circuit Replacement . Did you complete the repair? | Go to Step 10 | -- |
9 | Repair the open WHT/BLU wire between connector C1, cavity 6 of the instrument panel cluster assembly and S235. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 10 | -- |
10 | Operate the system in order to verify the repair. Did you correct the concern? | System OK | Go to Step 3 |
