For 1990-2009 cars only
Inspection Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the rubber plug from the brake back plate.
- Through the hole of the back plate, visually inspect for thickness of the brake shoe lining (2).
- If the lining thickness is less than the specified value, replace with new brake shoes.
Important: Inspect the brake shoes whenever you inspect for excessive pedal travel. Refer to Brake Pedal Travel in Hydraulic Brakes.
Measurement
The brake shoe lining should be 1.0-10.0 mm (0.04-0.39 in).
