Step | Action | Value | Yes | No |
|---|---|---|---|---|
DEFINITION: Any noise emitted from the front of the vehicle that is induced by VEHICLE SPEED or DRIVING TERRAIN as related to the front suspension. | ||||
1 |
Is there an abnormal noise present? | -- | System OK | |
2 |
Important: It may be necessary to compare this vehicle to an identical vehicle in order to determine if the customer's concern is a normal operating characteristic of the vehicle. Is there an abnormal noise present? | -- | ||
3 |
Has the repair been performed? | -- | -- | |
4 |
Are any components damaged? | -- | ||
5 | Repair any damaged components. Has the repair been performed? | -- | -- | |
6 |
Does any tire exhibit unusual wear? | -- | ||
7 |
Is the noise now emitted from the rear of the vehicle? | -- | ||
8 | Replace the tire(s) that are causing the noise. Has the repair been performed? | -- | -- | |
9 | Ensure that the ball joints and steering linkage are lubricated (if applicable). Lubricate or replace as necessary. Did you service any components? | -- | ||
10 |
Did you tighten any wheel nuts? | -- | ||
11 | Use your hands in order to push and pull the strut. Is the strut loose? | -- | ||
12 |
Is the strut loose? | -- | ||
13 | Replace the loose or worn strut components. Refer to Strut Assembly Replacement in Front Suspension. Has the repair been performed? | -- | -- | |
14 | Use your hands in order to push and pull on the stabilizer shaft. Is the stabilizer shaft loose? | -- | ||
15 |
Is the stabilizer shaft loose? | -- | ||
16 | Observe the location of the stabilizer shaft looseness. Is the looseness observed at the stabilizer shaft link(s)? | -- | ||
17 | Replace the stabilizer shaft link(s). Refer to Stabilizer Shaft Link Replacement in Front Suspension. Has the repair been performed? | -- | -- | |
18 | Replace the stabilizer shaft insulator(s) and/or bracket(s). Refer to Stabilizer Shaft Insulator Replacement in Front Suspension. Has the repair been performed? | -- | -- | |
19 | Inspect the control arms for looseness or movement. Is any looseness or movement observed? | -- | ||
20 |
Is the control arm loose? | -- | ||
21 | Replace any worn or loose control arm bushings. Refer to Front Lower Control Arm Bushing Replacement in Front Suspension. Has the repair been performed? | -- | -- | |
22 |
Caution: Do not spin the drive wheels faster than 55 km/h (35 mph) as indicated by the speedometer. This limit is necessary because the speedometer indicates only one half of the actual wheel speed when one drive wheel is spinning and the other drive wheel is stopped. Personal injury and damage may result from high speed spinning. Important: This step will require the assistance of another person to maintain the drive train speed. Do not use the cruise control to maintain the drivetrain speed. Important: Do not allow the stethoscope to contact any moving components. Does either wheel bearing exhibit noise? | -- | ||
23 | Replace the wheel bearings. Refer to Front Wheel Hub, Bearing, and Seal Replacement in Front Suspension. Has the repair been performed? | -- | -- | |
