GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Tracker - 2WD 🢒 Engine 🢒 Engine Controls - 2.0L 🢒 Accelerator Control Cable Replacement

Removal Procedure

    Object Number: 158305 Size: SH
  1. Disconnect the accelerator control cable (1) from the accelerator pedal (2).
  2. Push the accelerator control cable through the bulkhead grommet.

    3. Object Number: 55563 Size: SH
  3. Disconnect the accelerator control cable (1) from the throttle body by rotating the throttle lever (3) to wide open throttle (WOT) and removing the cable end from the slot.
  4. Loosen the accelerator control cable locknut and the accelerator control cable adjusting nut.
  5. Remove the accelerator control cable (1) from the vehicle.

Installation Procedure

    Object Number: 55563 Size: SH
  1. Install the accelerator control cable (1) to the cable bracket.
  2. Connect the accelerator control cable (1) to the throttle lever (3).
  3. Secure the accelerator control cable with the cable locknut and the adjusting nut. Do not tighten fully.

    4. Object Number: 158305 Size: SH
  4. Push the accelerator control cable through the bulkhead grommet.
  5. Connect the accelerator control cable (1) to the accelerator pedal (2).
  6. Adjust the accelerator control cable end play and the accelerator pedal free play. Refer to Accelerator Cable Adjustment .