GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 S10 Pickup - 2WD 🢒 Engine 🢒 Engine Controls - 2.2L (L43) 🢒 Fuel Tank Pressure Sensor Replacement

Removal Procedure

    Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.

  1. Raise the vehicle.
  2. Remove the fuel tank. Refer to Fuel Tank Replacement .

    3. Object Number: 373185 Size: SH
  3. Remove the fuel tank pressure sensor electrical connector.

    4. Object Number: 61945 Size: SH
  4. Remove the fuel tank pressure sensor.

Installation Procedure

    Object Number: 61945 Size: SH
  1. Install the fuel tank pressure sensor.

    2. Object Number: 373185 Size: SH
  2. Install the fuel tank pressure sensor electrical connector.
  3. Install the fuel tank. Refer to Fuel Tank Replacement .
  4. Lower the vehicle.
  5. Refill the fuel tank.
  6. Connect the negative battery cable.
  7. Inspect for fuel leaks through the following steps:
    8. 7.1. Turn ON the ignition for two seconds.
    7.2. Turn OFF the ignition for ten seconds.
    7.3. Turn ON the ignition.
    7.4. Check for fuel leaks.