For 1990-2009 cars only
Disassembly Procedure
- Use the following procedure in order to test the operation of the one-way clutch:
- Remove the one-way clutch No. 2 brake (6) from the sun gear (1).
- Remove the snap ring (5).
- Remove the No. 3 planetary carrier thrust washer (4) from the sun gear input drum (3).
- Remove the sun gear input drum (3) from the sun gear (1).
- You may remove the snap ring (2) from the sun gear.
- Pry off the retainers (7) using a screwdriver.
- Remove the one-way clutch.
- Inspect the one-way clutch and hub for excessive wear.
- Replace the necessary components if excessive wear is evident.
- Install the one-way clutch into the brake hub.
- Hold the brake hub in a vise with soft jaws.
- Install the retainers. Verify that the retainers are centered.
- Stake the tabs with a brass hammer and a punch.
- Test the operation of the one-way clutch.
| 1.1. | Turn the hub clockwise while holding the sun gear. |
The hub should turn freely.
| 1.2. | Turn the hub counterclockwise while holding the sun gear. |
The hub should lock.
The spring cage (2) should face inward from the flanged side (1) of the brake hub.
Assembly Procedure
- If you removed the shaft snap ring (2), reinstall the shaft snap ring onto the sun gear (1).
- Install the sun gear input drum (3) onto the sun gear (1).
- Install the No. 3 planetary carrier thrust washer (4) onto the sun gear input drum (3).
- Install the snap ring (5).
- Install the one-way clutch No. 2 brake hub (6) onto the sun gear (1).
- Slide the one-way clutch onto the inner race while turning the hub clockwise.
- Retest the operation of the No. 1 one-way clutch.
