Schematic Reference: Instrument Cluster Schematics

Did you review the Instrument Panel, Gages and Console Description and Operation and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Instrument Panel, Gages and Console

Verify that the chime is inoperative.

Does the system operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Connect a fused jumper wire to the LH front door jamb switch connector.
2. Connect the other side of the fused jumper wire to ground.
3. Set the conditions to cause a audible warning.

Does the chime sound?

Go to Step 4

Go to Step 5

Replace the LH front door jamb switch. Refer to Front Side Door Jamb Switch Replacement in Lighting Systems.

Is the repair complete?

Go to Step 8

--

1. Disconnect the ignition switch connector.
2. Connect a fused jumper wire from the ignition switch connector cavity 1 to cavity 2 of the same connector.
3. Set the conditions to cause an audible warning.

Does the chime sound?

Go to Step 7

Go to Step 6

Replace the multifunction alarm. Refer to Multifunction Alarm Module Replacement .

Is the repair complete?

Go to Step 8

--

Replace the ignition switch. Refer to Ignition Switch Replacement - On Vehicle in Steering Wheel and Column-Standard.

Is the repair complete?

Go to Step 8

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3