Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics

Did you perform the Lighting System Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Lighting Systems

1. Place the headlamp switch in the HEADLAMP position.
2. Place the headlamp dimmer switch in the LOW position.
3. Observe the headlamps.
4. Place the headlamp dimmer switch in the HIGH position.
5. Observe the headlamps.

Do both the low and high beam headlamps illuminate?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

Test for an open or high resistance in the ground circuit of the turn/headlamp switch. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 6

Go to Step 4

Inspect for poor connections at the turn/headlamp switch assembly. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 6

Go to Step 5

Replace the turn/headlamp switch assembly. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle in Steering Wheel and Column.

Did you complete the repair?

Go to Step 6

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2