Tools Required

J 39400-A Halogen Leak Detector

Important: The filter, ACDelco P/N-1760 must be installed to the A/C evaporator tube (liquid line) between the condenser and the evaporator. The installation of this in-line filter eliminates the need for flushing the A/C system.

1. Recover the A/C refrigerant. Refer to Refrigerant Recovery and Recharging .
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
3. Remove the right front fender liner. Refer to Front Fender Liner Replacement in Body Front End.

Important: Immediately cap or tape the open end of the condenser and evaporator line in order to prevent contamination of the A/C system.

4. Remove the evaporator line bolt at the condenser fitting. It may be necessary to turn the wheel all of the way to the right.

Important: The ACDelco P/N-1760 will have an orifice contained in it.

5. Remove and discard the orifice tube.



6. Make 2 marks 38 mm (1½ in) apart on the liquid line (1), approximately 50 mm (2 in) from the first line hanger and after the black foam line insulation.

Important: Do not allow metal burrs to drop into the liquid line.

7. Use a line cutter in order to cut the liquid line at the marked position (1). Remove any burrs.
8. Connect the evaporator line at the condenser fitting.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

9. Install the evaporator hose bolt.

Tighten
Tighten the evaporator hose bolt to 25 N·m (18 lb ft).

10. Remove the following components from the A/C refrigerant filter:

•

The nuts

•	The ferrules

•	The O-rings





Important: Do NOT install the O-rings at this step.

11. Push the nuts and the ferrules over each of the liquid line halves. Install the ferrules with the small end toward the nut.
12. Install the liquid line into the A/C refrigerant filter. Ensure to bottom out the liquid line.
13. While holding the liquid line bottomed out in the A/C refrigerant filter, tighten the nuts securely.
14. Disassemble the A/C refrigerant filter from the liquid line.
15. Lubricate the O-rings with clean 525 viscosity refrigerant oil.
16. Install the O-rings onto the liquid line.
17. Install the liquid line into the A/C refrigerant filter. Ensure to bottom out the liquid line.
18. While holding the liquid line bottomed out in A/C refrigerant filter, tighten the nuts securely.

Tighten
Tighten the nuts to 15 N·m (11 lb ft).

19. Evacuate and charge the refrigerant system. Refer to Refrigerant Recovery and Recharging
20. Leak test the fittings of the component using the J 39400-A .
21. Install the right front fender liner. Refer to Front Fender Liner Replacement in Body Front End.
22. Lower the vehicle.