For 1990-2009 cars only
Removal Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the oil filter. Refer to Engine Oil and Oil Filter Replacement .
- Remove the oil filter bypass hole plug.
- Insert a flat bladed tool into the oil filter bypass hole and force the bypass valve (1) out.
- Remove the oil filter bypass valve.
- If necessary, remove the oil filter fitting.
Installation Procedure
- Install the oil filter fitting.
- Install the oil filter bypass valve.
- Install the oil filter bypass valve (1) to the proper depth.
- Install the oil filter bypass hole plug.
- Install the oil filter.
- Lower the vehicle.
- Add engine oil as required. Refer to Engine Oil and Oil Filter Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the oil filter fitting to 39 N·m (29 lb ft).
Tighten
Tighten the oil filter fitting to 19 N·m (14 lb ft).
