For 1990-2009 cars only
Removal Procedure
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
- Remove fuel filler cap.
- Using compressed air, blow any dirt out of the quick-connect fitting.
- Squeeze the plastic retainer release tabs.
- Pull the connection apart.
Caution: Wear safety glasses when using compressed air in order to prevent eye injury.
Installation Procedure
- Apply a few drops of clean engine oil to the male fuel pipe end.
- Push both sides of the quick-connect fitting together in order to cause the retaining tabs to snap into place.
- Once installed, pull on both sides of the quick-connect fitting to ensure the connection is secure.
- Install the fuel filler cap.
- Connect the negative battery cable.
