For 1990-2009 cars only
Removal Procedure
- Remove the overhead console. Refer to Roof Console Replacement in Interior Trim.
- Disconnect the electrical connectors (5,6).
- Remove the screws from the back panel of the overhead console.
- Remove the back panel of the overhead console.
- Remove the screws (1) holding the universal garage door opener from the overhead console.
- Disconnect the electrical connector from the universal garage door opener.
- Remove the universal garage door opener from the overhead console.
Installation Procedure
- Connect the electrical connector from the universal garage door opener to the overhead console.
- Install the universal garage door opener to the overhead console.
- Install the screws (1) from the universal garage door opener to the overhead console.
- Install the back panel to the overhead console.
- Install the screws to hold the back panel to the overhead console.
- Connect the remaining electrical connectors (5,6) from the overhead console to the vehicle.
- Install the overhead console to the vehicle. Refer to Roof Console Replacement in Interior Trim.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the universal garage door opener screws to 2 N·m
(18 lb in).
