Control Assembly Replacement w/ C60

1. Remove the bezel--IP cluster. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
2. Remove the Radio. Refer to Radio Replacement .



3. Remove the heater control assembly by firmly depressing and holding the retaining tabs and then sliding the assembly away from the dash.



4. Disconnect the temperature and mode cables from the back of the control head.
5. Disconnect the electrical connection from the control head.
6. Remove the control head.

1. Connect the electrical connection to the control head.



2. Connect the temperature and mode cables to the back of the control head.



3. Install the control head to the I/P carrier until a snap is heard.
4. Install the radio. Refer to Radio Replacement .
5. Install the bezel--I/P cluster. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .