Diagnostic Aids
Clutch grabbing happens when the clutch is disengaged and the vehicle lurches or shudders. In many instances it could be the engine mounts are loose or damaged. If this condition still exist, remove the transmission and inspect the pressure plate for burned or smeared resin from the clutch disc, and for oil on the pressure plate. Inspect for a worn or damaged release bearing and the splines on the transmission main drive gear.
Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
This step explains the parts and the operation of the clutch system.
-
This step inspects for faulty engine mounts
-
This step inspects for fluid leakage on the clutch system components.
Step | Action | Yes | No |
|---|---|---|---|
DEFINITION: The clutch grabs or chatters during engagement. | |||
Did you review the clutch symptom operations and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Clutch | |
Inspect the engine mounts. Are the engine mounts loose or tightened out of sequence? | Go to Step 3 | Go to Step 4 | |
3 | Tighten the engine mounting fasteners to the specified torque. Refer to Fastener Tightening Specifications in Engine Mechanical 6.5L or Fastener Tightening Specifications in Engine Mechanical 8.1L. Does the clutch still grab? | Go to Step 4 | System OK |
4 | Inspect for a damaged engine mount. Is the engine mounting damaged? | Go to Step 5 | Go to Step 6 |
5 | Replace the engine mount. Refer to Engine Mount Replacement - Left Side in Engine Mechanical 6.5L or Engine Mount Replacement - Left Side in Engine Mechanical 8.1L and Engine Mount Replacement - Right Side in Engine Mechanical 6.5L or Engine Mount Replacement - Right Side in Engine Mechanical 8.1L . Does the clutch still grab? | Go to Step 5 | System OK |
6 |
Is there burned or smeared resin on the pressure plate? | Go to Step 7 | Go to Step 8 |
7 | If the pressure plate has burns or smears, clean or sand off the excess resin. If the pressure plate assembly is burned or has heat checked parts, replace the pressure plate assembly. Refer to Clutch Assembly Replacement . Does the clutch still grab? | Go to Step 8 | System OK |
8 | Inspect for a warped or damaged pressure plate. Is the pressure plate warped? | Go to Step 9 | Go to Step 10 |
9 | Replace the pressure plate. Refer to Clutch Assembly Replacement . Did you find and repair the condition? | System OK | Go to Step 10 |
10 | Inspect for transmission fluid or oil on the clutch pressure plate facing, or a burned or glazed facing. Is there fluid on the clutch pressure plate facing or a burned or glazed facing? | Go to Step 11 | Go to Step 12 |
Correct the leak at the source. Refer to Oil Leak Diagnosis in Engine Mechanical - 6.5L or Oil Leak Diagnosis in Engine Mechanical - 8.1L. Install a new clutch pressure plate. Does the clutch still grab? | Go to Step 12 | System OK | |
12 | Inspect for worn splines on the transmission main drive gear. Are there worn splines on the transmission main drive gear? | Go to Step 13 | Go to Step 14 |
13 | Inspect the release bearing at the transmission main drive gear. Is the release bearing binding? | Go to Step 14 | -- |
14 | Replace the release bearing. Refer to Clutch Concentric Actuator Cylinder Replacement . Did you find and repair the condition? | Go to Step 15 | Go to Diagnostic Aids |
15 |
Did you correct the condition? | System OK | Go to Step 1 |
