1. Disconnect the IP cluster connector at the instrument cluster.
2. Place the ignition switch in the RUN position.
3. Connect a test lamp from CKT 39 (PNK) at instrument cluster harness connector terminals 9, 27, 32, and chassis ground.

Did the test lamp light?

--

Go to Step  2

Go to Step 3

Use a J 39200 DMM between instrument cluster connector terminals 15, 20, 25, and chassis ground.

Does the DMM indicate continuity?

Go to Instrument Cluster Replacement

Go to Step 4

Locate and repair the open in CKT 39 (PNK) between the IP fuse block IGN 1 circuit breaker and the IP cluster harness connector.

Is the repair complete?

--

System OK

--

Locate and repair the open in CKT 250/150 (BLK) between the instrument cluster and ground.

Is the repair complete?

System OK

--