Removal Procedure
- Remove the front intake
air duct (1) from the air filter housing.
- Remove the front wheelhouse panel. Refer to
Wheelhouse Panel Replacement
.
- Drain the coolant. Refer to
Cooling System Draining and Filling
.
- Remove the surge tank hose clamp (3).
- Remove the radiator outlet
hose (4) and the clamp (5) from the radiator (1).
- Remove the radiator outlet hose (4) and the clamp from the water
pump.
Installation Procedure
- Install the radiator outlet
hose (4) and the clamp to the water pump.
- Install the surge tank hose clamp (3).
Tighten
Tighten the clamps to 5 N·m (44 lb in).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the radiator
outlet hose (4) and the clamp (5) to the radiator (1).
Tighten
Tighten the clamps to 5 N·m (44 lb in).
- Install the front air
intake duct (1) to the air filter housing.
- Install the front wheelhouse panel. Refer to
Wheelhouse Panel Replacement
.
- Fill the cooling system. Refer to
Cooling System Draining and Filling
.
- Inspect the system for leaks.