LABOR TIME FOR BENCH OVERHAUL (RPO MG1, MG2)

Model and Year: 1987-88 CAVALIER, CELEBRITY, CORSICA, BERETTA WITH HM-282 TRANSAXLE

Bench overhaul labor time for service of the 1987/88 HM-282 manual transaxle. Use the bench overhaul time listed until the March, 1988 Labor Time Guide revision is published.

HM-282 TRANSAXLE 5-SPEED

OPERATION DESCRIPTION OPERATION VEHICLE SERIES NUMBER A J L -------------------- --------- ---------------

TRANSAXLE ASSEMBLY - RECONDITION K3100 INC: R&R transaxle, replace clutch release bearing, adjust shift linkage. --- 2.3 ---

--- --- --- 6-CYLINDER 2.3 3.5 3.5

ADD:

A) TO CHECK SHIM SELECTION ONLY* 2.6 2.6 2.6

NOTE: Shim selection time is included when required on the following adds.

B) TO REPLACE RING GEAR* 1.3 1.3 1.3

C) TO REPLACE SIDE GEARS AND PINIONS* 1.4 1.4 1.4

D) TO REPLACE AXLE HOUSING SIDE BEARINGS* 2.8 2.8 2.8

E) TO REPLACE AXLE CASE HALF (BELL HOUSING)* 1.2 1.2 1.2

F) TO REPLACE SHIFTER FORKS AND/OR INTERLOCK* 1.6 1.6 1.6

G) TO REPLACE SHIFTER SHAFT* 1.1 1.1 1.1

H) TO RECONDITION INPUT SHAFT* 1.9 1.9 1.9

I) TO REPLACE SPEEDOMETER DRIVE GEAR* 1.2 1.2 1.2

J) TO RECONDITION OUTPUT SHAFT* 2.1 2.1 2.1

K) TO REPLACE TRANS CASE HALF* 2.3 2.3 2.3

L) TO RECONDITION TRANSAXLE COMPLETE* 4.6 4.6 4.6

NOTE: TOTAL ADD TIME NOT TO EXCEED THE "RECONDITION TRANSAXLE" ADD TIME.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.