- Remove the key from the ignition switch.
- Connect the inflatable restraint IP module inline connector located under
the instrument panel, left of the steering column.
- Install the connector position assurance (CPA)
to the inflatable restraint IP module inline connector.
- Connect the inflatable restraint steering wheel
module coil connector located under the instrument panel, left of the steering column.
- Install the CPA to the inflatable restraint steering
wheel module coil connector.
- Install the AIR BAG fuse to the LH IP wiring
harness junction block.
- Install the LH IP outer trim cover. Refer to
Instrument Panel Outer Trim Cover Replacement
.
- Staying well away from both air bags, turn ON the ignition.
8.1. | The AIR BAG indicator will flash seven times. |
8.2. | The AIR BAG indicator will then turn OFF. |
- Perform the
Diagnostic System Check - SIR
if the AIR BAG indicator
does not operate as described.