Caution: Refer to Halogen Bulb Caution in the Preface section.

1. Remove the hood close out filler panel. Refer to Hood Close Out Filler Replacement in Body Front End.
2. Remove the park/turn signal lamp. Refer to Parking and Turn Signal Lamp Replacement .
3. Remove the bolts (6) from the headlamp.
4. Remove the headlamp from the headlamp mounting panel.
5. Disconnect the electrical connector from the headlamp.



6. Remove the headlamp bulb/socket retainer ring from the headlamp.



7. Remove the headlamp bulb/socket from the headlamp.



8. Remove the bolts from the headlamp adjuster mechanism, if required.
9. Remove the headlamp adjuster mechanism, if required.

1. Install the headlamp bulb/socket to the headlamp.



2. Install the headlamp bulb/socket retainer ring to the headlamp.



3. Install the headlamp adjuster mechanism to the headlamp housing, if necessary.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the bolts to the headlamp adjuster mechanism, if required.

Tighten
Tighten the headlamp adjuster mechanism bolts to 6 N·m (53 lb in).




5. Connect the electrical connector to the headlamp.
6. Position the headlamp to the headlamp mounting panel and lower mounting bracket.
7. Install the bolts (6) from the headlamp.

Tighten
Tighten the headlamp bolts (6) to 10 N·m (89 lb in).

8. Install the park/turn signal lamp. Refer to Parking and Turn Signal Lamp Replacement .
9. Install the hood close out filler panel. Refer to Hood Close Out Filler Replacement in Body Front End.
10. Check and adjust the headlamp aim as necessary. Refer to Headlamp Aiming .