GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Cavalier 🢒 Engine 🢒 Engine Controls - 2.2L (LN2) 🢒 Accelerator Pedal Replacement

Removal Procedure

    Object Number: 14159 Size: SH
  1. Release the cable (1) retainer from the accelerator pedal lever.
  2. Remove the accelerator pedal assembly attaching nuts.
  3. Remove the pedal assembly (2).

Installation Procedure

    Object Number: 14159 Size: SH
  1. Install the pedal assembly (2) to the cowl.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the nuts to the cowl.

    3. Tighten
    Tighten the nuts to 30 N·m (22 lb ft).

  3. Install the accelerator cable (1) through the slot in the accelerator pedal assembly (2) and snap into place.
  4. Inspect for correct opening and closing positions by operating the accelerator pedal. Ensure that the throttle valve reaches a wide open throttle (WOT) position. If the throttle valve does not open properly, inspect for damaged or bent brackets, levers, or other components. Also inspect for poor carpet fit under the accelerator pedal.