Rear Bumper Fascia Replacement Chevrolet

1. Remove the upper storage net retainers (3) inside the compartment in order to access the fascia screws.



2. Remove the screws (3) from the inside of the rear compartment.
3. Remove the screws (2) from the rear fascia. The screws are located in the rear wheel housing.



4. Remove the push-pin retainers (2) from the lower fascia (1).



5. Remove the rear fascia (1) from the impact bar.

1. Install the rear fascia (1) to the impact bar.



2. Install the push-pin retainers (2) to the lower fascia (1).




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the screws (2) to the rear fascia. The screws are located in the rear wheel housing.

Tighten
Tighten the nuts to 9 N·m (80 lb in).

4. Install the screws (3) to the rear compartment.



5. Install the upper storage net retainers (3) to the inside rear compartment.

Rear Bumper Fascia Replacement Pontiac

1. Remove the upper storage net retainers (3) inside the rear compartment in order to access the fascia screws.



2. Remove the screws (4) from the inside of the rear compartment.
3. Remove the screws (3) from the rear fascia. The screws are located in the rear wheel housing.



4. Remove the push-pin retainers (2) from the lower fascia (1).



5. Remove the rear fascia (3) from the impact bar (1).

1. Install the rear fascia (3) to the impact bar (1).



2. Install the push-pin retainers (2) to the lower fascia (1).




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the screws (3) to the rear fascia. The screws are located in the rear wheel housing.

Tighten
Tighten the nuts to 9 N·m (80 lb in).

4. Install the screws (4) to the rear compartment.



5. Install the upper storage net retainers (3) to the inside rear compartment.