Did you perform the Instrument Cluster Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Instrument Cluster

Verify the fault is present.

Does the system operate properly?

Go to Testing for Intermittent and Poor Connections in Wiring Systems

Go to Step 3

1. Turn OFF the ignition.
2. Disconnect the instrument cluster connector and remove the connector combs.
3. Turn ON the ignition, with the engine OFF.
4. With a test lamp, backprobe between the battery positive voltage circuit and ground.

Does the test lamp illuminate?

Go to Step 4

Go to Step 8

With a test lamp, backprobe between the battery positive voltage circuit and the ground circuits.

Does the test lamp illuminate for each ground circuit?

Go to Step 5

Go to Step 7

With a test lamp, backprobe between the ignition 0 voltage circuit and ground.

Does the test lamp illuminate?

Go to Step 9

Go to Step 6

Repair the open or short to ground in the Ignition 0 voltage circuit. Refer to Wiring Repairs in Wiring Systems.

Did you complete the repair?

Go to Step 11

--

Repair the open in the inoperative ground circuit. Refer to Wiring Repairs in Wiring Systems.

Did you complete the repair?

Go to Step 11

--

Repair the open or short to ground in the battery positive voltage circuit. Refer to Wiring Repairs in Wiring Systems.

Did you complete the repair?

Go to Step 11

--

Test for an open or short to ground in the battery positive voltage feed to the BCM (CKT 1440).

Did you find and correct the condition?

Go to Step 11

Go to Step 10

Replace the instrument cluster.

Refer to Instrument Cluster Replacement .

Did you complete the replacement?

Go to Step 11

--

Operate the system in order to verify the repair.

Does the system operate properly?

System OK

Go to Step 3