Console Replacement Chevrolet

1. Open the console compartment.
2. Refer to Console Trim Plate Replacement in order to remove one of the following components:

•	The console trim plate - automatic transmission

•	Disconnect the shift indicator connector.

•	The boot - manual transmission

3. Remove the screw cover (7).
4. Remove the  screws (6).
5. Remove the console (2).

1. Install the console (2).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the screws (6).

Tighten
Tighten the screws to 2 N·m (18 lb in).

3. Install the screw cover (7).
4. Refer to Console Trim Plate Replacement in order to install one of the following components:

•	The console trim plate - automatic transmission

•	The boot - manual transmission

5. Close the console compartment.

Console Replacement Pontiac

1. Remove the retainer clip from the shift control handle.
2. Disconnect the enhanced traction system (ETS) wire connector and pull the wire through the shift boot.
3. Disconnect the shift light indicator connector.



4. Remove the shift boot (2).



5. Remove the console compartment liner (1).
6. Remove the screws (2).
7. Remove the console (3).

1. Install the console (3).
2. Install the screws (2).
3. Install the console compartment liner (1).



4. Install the shift boot (2).
5. Pull the ETS wire through the shift boot and connect the ETS wire to the connector.
6. Install the shift control boot with the Velcro retainer.
7. Install the shift control handle retainer.