Was the Lighting Systems Diagnostic System Check Performed?

Go to Step 2

Go to Diagnostic System Check - Lighting Systems

1. Disconnect the turn/headlamp switch assembly connector C2.
2. Test for an open in the ground circuit 251 (terminal E). Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Was an open found and corrected?

System OK

Go to Step 3

Inspect for poor connections at the turn/headlamp switch assembly. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

System OK

Go to Step 4

Replace the turn/headlamp switch assembly. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle .

Is the repair complete?

System OK

--