The roof is made of steel and welded to the steel roof structure. The roof panel is supplied as part of an assembly that includes the center roof support. The roof assemblies are unique to the coupe and the sedan models.

Important: Remove the following components before removing the roof assembly.

1. Remove all of the related panels and components in order to gain proper access to the welds attaching the roof assembly to the vehicle.
2. Remove the following components as necessary.

•	Windshield

•

Backlight

•	Left and right quarter glass appliques (on coupe models)

3. Locate and mark the factory welds. Note the number and location of welds for installation of the service part.
4. Drill out the factory welds.



5. Remove both the roof panel and the center roof support.

1. Prepare mating surfaces and inspect for proper fit of the roof assembly.
2. Apply urethane memory tape to the front and rear roof bows before installing the roof panel.
3. Position the roof panel. Inspect the fit using body dimensions and plug weld accordingly with frequent measurements in order to ensure proper fit.
4. Clean and prepare the welded surfaces.

Important: Prior to refinishing, refer to GM 4901 Refinish Manual for recommended products. Do not combine paint systems. Refer to paint manufacturer's recommendations.

Do not top-coat any windshield bonding surface.
5. Prime with two-part catalyzed primer.
6. Apply the sealers and the corrosion protection materials.
7. Reinstall all of the related panels and components.