Tools Required

J 41239-10 Cooler Line Seal Remover

Caution: Refer to Vehicle Lifting Caution in the Preface section.

1. Raise the vehicle. Support the vehicle.
2. Remove the transmission oil cooler pipes from the transmission. Refer to Automatic Transmission Oil Cooler Pipes Replacement



3. Remove the cooler pipe bracket stud.



4. Remove the oil cooler pipe seals.

Tools Required

J 41239-1A Cooler Line Seal Installer

1. Install the J 41239-1A on the transmission case using cooler pipe bracket stud hole.
2. Press the new seals in. Tighten the J 41239-1A until the seal bottoms out in the case bore.



3. Install the cooler pipe bracket stud.
4. Install the transmission oil cooler pipes. Refer to Automatic Transmission Oil Cooler Pipes Replacement .
5. Lower the vehicle.
6. Inspect the transmission fluid level. Refer to Transmission Fluid Check .
7. Operate the engine for 2 or 3 minutes.
8. Inspect the transmission fluid level. Refer to Transmission Fluid Check .