Test Description
The number(s) below refer to the step number(s) on the diagnostic table.
-
Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
-
The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
-
DTC B1000 and DTC B1001 are internal BCM malfunctions and should be corrected before performing any other diagnostic procedure.
-
DTC B1328 sets when battery voltage is above 18.5 volts and should be corrected before performing any other diagnostic procedure.
Step | Action | Yes | No |
|---|---|---|---|
1 | Install a scan tool. Does the scan tool power up? | Go to Step 2 | Go to Scan Tool Does Not Power Up in Data Link Communications |
Does the scan tool communicate with the body control module and EBCM? | Go to Step 3 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | |
3 | Select the body control module display DTCs function and the EBCM display DTCs function on the scan tool. Does the scan tool display any DTCs? | Go to Step 4 | Go to applicable symptom table |
Does the scan tool display any DTCs which begin with a "U"? | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | Go to Step 5 | |
Does the scan tool display DTC B1000 or B1001? | Go to Diagnostic Trouble Code (DTC) List/Type in Body Control System | Go to Step 6 | |
Does the scan tool display DTC B1328? | Go to Diagnostic Trouble Code (DTC) List/Type in Engine Electrical |
