Step | Action | Yes | No | ||||||
---|---|---|---|---|---|---|---|---|---|
1 | Did you perform the Instrument Cluster Diagnostic System Check? | Go to Step 2 | |||||||
2 |
Does the low coolant indicator lamp turn ON and OFF when commanded? | Go to Step 3 | Go to Step 4 | ||||||
3 |
Does the LOW COOLANT LEVEL parameter display ON? | Go to Step 5 | Go to Step 6 | ||||||
4 | Replace the instrument cluster (IPC). Refer to Instrument Cluster Replacement or Instrument Cluster Replacement . Did you complete the repair? | Go to Step 11 | -- | ||||||
5 | Inspect for poor connections at the harness connector of the low coolant switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 11 | Go to Step 7 | ||||||
6 | Test the ground circuit of the low coolant switch for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 11 | Go to Step 8 | ||||||
7 | Replace the low coolant switch. Did you complete the replacement? | Go to Step 11 | -- | ||||||
8 | Test the signal circuit of the low coolant switch for the following conditions:
Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 11 | Go to Step 9 | ||||||
9 | Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 11 | Go to Step 10 | ||||||
10 | Replace the BCM. Refer to Body Control Module Replacement in Body Control System. Important: Perform the setup procedure for the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration . Did you complete the replacement? | Go to Step 11 | -- | ||||||
11 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |