For 1990-2009 cars only
Removal Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the oil filter. Refer to Engine Oil and Oil Filter Replacement .
- Verify that the gasket is removed with the filter.
- Remove the oil filter adapter.
- Remove the oil filter bypass valve using a screwdriver or a punch in order to pry the valve out.
- Clean the oil filter mounting surface.
Installation Procedure
- Install the oil filter bypass valve. Seat the valve using a socket of the same diameter and a mallet.
- Install the oil filter adapter.
- Install the filter. Turn the filter ¾-1 complete turn after the gasket contacts the surface of the block. Refer to Engine Oil and Oil Filter Replacement .
- Lower the vehicle.
- Top off engine oil.
- Start the vehicle and check for leaks.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the oil filter adapter to 29 N·m (21 lb ft).
