Tools Required

J 25070 Heat Gun

1. Mark the position of the molding with a length of masking tape.
2. Heat the molding using the J 25070 . Apply heat using a circular motion for about 30 seconds.

Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.

3. Remove the molding from the fender using a plastic flat-bladed tool.
4. Wash the area with soapy water and wipe dry.
5. Remove all traces of adhesive using an oil-free naptha or alcohol.

Important: Do not touch the adhesive backing on the molding.

1. Remove the backing from the molding.
2. Measure 2.5-4.5 mm (0.1-0.18 in) from the rear edge of the fender (1) to the inside of the molding.
3. Align the molding to the guideline and press firmly in place.