GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Camaro 🢒 Steering 🢒 Power Steering System 🢒 Power Steering Fluid Reservoir Bracket Replacement

Removal Procedure

    Object Number: 290572 Size: SH
  1. Remove the reservoir (1) from the bracket (2).
  2. Use a wire, or an equivalent, in order to secure the reservoir (1) in an upright position.

    3. An upright position will prevent leakage.

  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Remove the electrical harness from the bracket (2).

    5. Object Number: 290571 Size: SH
  5. Remove the bolt/screw (1).
  6. Remove the nuts (2).

Installation Procedure

    Object Number: 290571 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the nuts (2).

    2. Tighten
    Tighten the nuts to 12 N·m (107 lb in).

  2. Install the bolt/screw (1).

    3. Tighten
    Tighten the bolt/screw to 50 N·m (37 lb ft).

  3. Install the electrical harness to the bracket (3).
  4. Lower the vehicle.

    5. Object Number: 290572 Size: SH
  5. Install the reservoir (1) to the bracket (2).