The Engine Scan Tool Data List contains all engine related parameters that are available on the scan tool. The list is arranged in alphabetical order. A given parameter may appear in any one of the data lists, and in some cases may appear more than once, or in more than one data list in order to group certain related parameters together.
Use the Engine Scan Tool Data List only after the following is determined:
• | Powertrain On-Board Diagnostic System Check is completed. |
• | No diagnostic trouble codes (DTCs). |
• | On-board diagnostics are functioning properly. |
Scan tool values from a properly running engine may be used for comparison with the engine you are diagnosing. The Engine Scan Tool Data List represents values that would be seen on a normally running engine.
Important: A scan tool that displays faulty data should not be used. The scan tool concern should be reported to the manufacturer. Use of a faulty scan tool can result in misdiagnosis and unnecessary parts replacement.
Only the parameters listed below are referenced in this service manual for use in diagnosis. If all values are within the typical range described below, refer to Symptoms for diagnosis.
The column labeled Data List indicates where a parameter can be located on the scan tool. Refer to the scan tool operating manual for the exact locations of the data lists. The following is a description of each term listed:
All : The Parameter is in all data lists indicated below.Scan Tool Parameter | Data List | Parameter Range/Units | Typical Data Values |
---|---|---|---|
Engine Idling/Radiator Hose Hot/Closed Throttle/Park or Neutral/Closed Loop/Accessories Off | |||
A/C High Side Pressure | Eng 2 | 0-5 volts | Varies |
A/C High Side Pressure | Eng 2 | kPa/psi | Varies |
A/C Relay Command | Eng 1, 2, EE, MF | On/Off | Off |
A/C Request | Eng 1, 2, EE, MF | Yes/No | No |
A/C Status | Eng 1, 2, EE, MF | On/Off | Off |
Actual EGR Position | Eng 1 | 0-100% | 0% |
AIR Pump Relay | Eng 1, 2, FT | On/Off | Off |
AIR Solenoid | Eng 1, 2, FT | On/Off | Off |
Air Fuel Ratio | FF, FR | Ratio | 14.7:1 |
BARO | Eng 1, FT, FF, FR | kPa/Volts | 65-104 kPa/3.5-4.9 Volts (Varies w/Altitude) |
CAM Signal Input High to Low | Eng 1 | Counts | Varies |
CAM Signal Input Low to High | Eng 1 | Counts | Varies |
Clutch Pedal Position Switch | Eng1, 2, MF | Depressed/Released | Varies |
Cold Startup | Eng1, 2, EE | Yes/No | Varies |
Commanded EGR | Eng 1 | 0-5 Volts | Less than 1.3 volts |
Cruise Requested | Eng1, 2 | Yes/No | No |
Cruise Control Inhibit | Eng1, 2 | Yes/No | Yes |
Current Gear | Eng 2, FF, FR | Transmission Gear Position | 1 |
Cycles of Misfire Data | MF | 0-100 Counts | Varies |
Cylinder Mode Misfire Index | MF | Counts | Varies |
DTC Set This Ignition | Eng 1, 2, EE, FT | Yes/No | No |
Desired IAC Airflow | Eng 1 | 0-64 g/s | Varies |
Desired EGR Position | Eng 1 | 0-100% | 0% |
Desired Idle Speed | Eng 1, FF, FR | RPM | PCM Controlled |
ECT | Eng 1, 2, EE, FT, MF, FF, FR | -39° to 140°C (-38° to 284°F) | 85° to 113°C (185° to 235°F) |
EGR Closed Pintle Position | Eng 1 | 0-5.0 Volts | Less than 1.3 volts |
EGR Pintle Position | Eng 1 | 0-5.0 Volts | Less than 1.3 Volts |
Engine Load | MF, FF, FR | 0-100% | 1-4% @ Idle 5-9% @ 2500 RPM |
Engine Run Time | Eng 1, 2, EE, FF, FR | Hrs, Min, Sec | Varies |
Engine Speed | All | 0-10,000 RPM | Varies |
EVAP Canister Purge | Eng 1, 2, EE, FT, FR | 0-100% | 0-25% |
EVAP Canister Vent Valve | Eng 1, 2, EE, FT | Not Venting/Venting | Venting |
Fail Counter | FR | Counts | Varies |
Failures Since First Fail | FR | Counts | Varies |
FC Relay 1 | Eng 1, 2, EE | On/Off | Depends on engine coolant temperature and A/C Pressure |
FC Relay 2 and 3 | Eng 1, 2, EE | On/Off | Depends on engine coolant temperature and A/C Pressure |
FT Diag. Inhibit | FT | Enabled/Disabled | Varies |
Fuel Gauge Control | Eng 2, EE | 0-100% | Varies |
Fuel Level Sensor | Eng 2, EE | 5-0 Volts | 0.7-2.5 Volts |
Fuel Tank Level Remaining | Eng 2, EE, FT | 0-16.6 gal./0-62.8 L | Varies |
Fuel Tank Level Remaining | Eng 2, EE, FT | 0-100% | Varies |
Fuel Tank Pressure | Eng 1, 2, EE | -32.7 to 14.0 mm/Hg (-17.5 to 7.5 in/H2O) | Varies |
Fuel Tank Pressure | Eng 2, EE | 0-5.0 Volts | Varies |
Fuel Tank Rated Capacity | Eng 2, EE, FT | 16.6 gal./62.8 L | 16.6 gal./62.8 L |
Fuel Trim Cell | Eng 1, FT | 0-23 | 16, 17, 20 |
Fuel Trim Learn | Eng 1, 2, EE, FT | Enabled/Disabled | Enabled (may Toggle) |
Generator L Terminal | Eng 2, | Active/Inactive | Active |
HO2S Bank 1 Sensor 1 | Eng 1, FT | Millivolts | 10-1,000 mV and Varying |
HO2S Bank 1 Sensor 2 | Eng 1, FT | Millivolts | 10-1,000 mV and Varying |
HO2S Bank 2 Sensor 1 | Eng 1, FT | Millivolts | 10-1,000 mV and Varying |
HO2S Bank 2 Sensor 2 | Eng 1, FT | Millivolts | 10-1,000 mV and Varying |
IAC Position | Eng 1 | Counts | Varies |
IAT | Eng 1, 2, EE, FT | -39° to 140°C (-38° to 284°F) | Varies |
IC Circuit Cylinder 1-8 | MF | Ok/Fault | Ok |
Ignition 1 | Eng 2, EE | 0-25 Volts | 11.5-14.5 Volts |
Inj. PWM Average Bank 1 | Eng 2, EE, FT, FF, FR | Milliseconds | 1-4 |
Inj. PWM Average Bank 2 | Eng 2, EE, FT, FF, FR | Milliseconds | 1-4 |
Knock Retard | Eng 1, EE, FT | 0.0°-16° | 0° |
Long Term FT 1 Average | FT | Percentage | Near 0% |
Long Term FT 2 Average | FT | Percentage | Near 0% |
Long Term FT Bank 1 | Eng 1, 2, EE, FT, FF, FR | Percentage | Near 0% |
Long Term FT Bank 2 | Eng 1, 2, EE, FT, FF, FR | Percentage | Near 0% |
Loop Status | Eng 1, 2, EE, FT MF, FF, FR | Open/Closed | Closed |
Low Oil Lamp | Eng 2 | On/Off | Off |
Low Oil Level | Eng 2 | Yes/No | No |
MAF | Eng 1, 2, EE, FT, MF, FF, FR | Grams Per Seconds (g/s) | 5-9 g/s@ Idle (depends on altitude) 20-26 g/s @ 2,500 RPM (depends on altitude) |
MAF Frequency | Eng 2 | 0-31,999 Hz | Varies |
MAP | Eng 1, 2, EE, FT, FF, FR | kPa/Volts | 20-48 kPa/1.0-2.0 Volts (varies w/altitude) |
MIL | Eng 1, 2, EE | Off/On | Off |
Mileage Since DTC Cleared | Eng 2 | km/Miles | Varies |
Mileage Since First Failure | FF, FR | km/Miles | Varies |
Mileage Since Last Failure | FR | km/Miles | Varies |
Mileage Since MIL Request | FF | km/Miles | Varies |
Misfire Current #1-#8 | MF | 0-200 Counts | 0 |
Misfire History #1-#8 | MF | 0-65,535 Counts | 0 |
Misfiring Cylinder | MF | Prim. Cyl# 0-8 Sec. Cyl# 0-8 | 00000000 Prim. 00000000 Sec. |
Misfire Revolution Status | MF | Reject/Accept | Varies |
Not Run Counter | FR | Counts | Varies |
PCM Reset | Eng 1, 2, MF | Yes/No | No |
PNP (A/T only) | Eng 2 | Park/Neutral R-D321 | Park/Neutral |
Pass Counter | FR | Counts | Varies |
Reverse Inhibit (M/T only) | Eng 1, 2 | Yes/No | No |
Revolutions With Misfire | MF | Counts | 0 |
SHRT FT Average 1 | FT | Percentage | Near 0% |
SHRT FT Average 2 | FT | Percentage | Near 0% |
Short Term FT Bank 1 | Eng 1, 2, EE, FT, FF, FR | Percentage | Near 0% |
Short Term FT Bank 2 | Eng 1, 2, EE, FT, FF, FR | Percentage | Near 0% |
Skip Shift Lamp (M/T only) | Eng 1, 2 | On/Off | Off |
Skip Shift Solenoid (M/T only) | Eng 1, 2 | Enabled/Disabled | Disabled |
Spark | Eng 1, 2, EE, FT, MF | Degrees | Varies |
Start Up ECT | Eng 1, FF, FR, EE | C°/F° | Varies |
TCC Brake Switch | Eng 1, 2, FF, FR | Applied/Released | Released |
TCC Duty Cycle | Eng 1, 2, MF, FF, FR | Enabled/Disabled | Disabled |
TCC Enable Sol. | Eng 1, 2, MF, FF, FR | Enabled/Disabled | Disabled |
Total Misfire Current Count | MF | Counts | 0 |
Total Misfire Failures Since First Fail | MF | 0-65,535 | 0 |
Total Misfire Passes Since First Fail | MF | 0-65,535 | 0 |
TP Sensor | Eng 2 | 0-5.0 Volts | .4-.9 Volts |
TP Angle | Eng 1, 2, EE, FT, MF, FF, FR | 0-100% | 0% |
Traction Control | Eng 1, 2, FF, FR | Active/Inactive | Inactive |
Transmission OSS | FF, FR | RPM | Varies |
Transmission Range | Eng 1, 2, FF, FR | 0-4 | 1 |
Vehicle Speed | Eng 1, 2, EE, FT, FF, FR | km/h mph | 0 |
VTD Fuel Disable | Eng 2, FF, FR | Active/Inactive | Inactive |
Warm-Ups w/o Emission Faults | Eng 2 | 0-255 Counts | Varies |
Warm-Ups w/o Non-Emission Faults | Eng 2 | 0-255 Counts | Varies |