GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Camaro 🢒 Engine 🢒 Engine Controls - 5.7L 🢒 Air Cleaner Assembly Replacement

Removal Procedure

    Notice: If the mass air flow (MAF) sensor is installed backwards, the system will go rich. An arrow cast into the plastic portion of the sensor indicates proper air flow direction. The arrow must point toward the engine.


    Object Number: 243934 Size: SH
  1. Release the top cover latches (4).
  2. Remove the plastic rivets (1) securing the air intake resonator (2).
  3. Loosen the clamp at the air duct between the MAF sensor and the resonator (2).

    4. Object Number: 242662 Size: SH
  4. Disconnect the IAT sensor (2) connector.
  5. Lift the top of the air cleaner housing and the resonator off as an assembly .

    6. Object Number: 243934 Size: SH
  6. Remove the 4 fasteners securing the air cleaner assembly (3) to the tie bar.
  7. Lift the lower air cleaner assembly off.

Installation Procedure

    Object Number: 243934 Size: SH
  1. Position the lower air cleaner assembly (3) on to the tie bar. Ensure the rubber isolators fit properly on to the top of the radiator.
  2. Fasten the lower air cleaner assembly (3) to the tie bar support.
  3. Secure the upper air cleaner and resonator assembly (2) to the MAF sensor
  4. Secure the resonator to the lower air cleaner assembly using the plastic rivets (1).

    5. Object Number: 242662 Size: SH
  5. Connect the IAT sensor (2) connector.
  6. Tighten the clamp on the air duct at the MAF sensor (1).

    7. Object Number: 243934 Size: SH
  7. Secure the top cover latches (4). Ensure the rear locating tabs on the air cleaner cove slip into the retainers located on the lower portion of the air cleaner housing.